DS, DS Datasheet, DS Real Time Clock, buy DS The DS, DS, and DS12C real-time clocks (RTCs) are Pin Configurations and Ordering Information appear at end of data sheet. WWW. Y. DESCRIPTION. The DS Real Time Clock plus RAM is designed to be a direct replacement for the DS The DS is identical in form, fit, and.

Author: Maujin Mikataxe
Country: Yemen
Language: English (Spanish)
Genre: Life
Published (Last): 9 September 2008
Pages: 291
PDF File Size: 7.23 Mb
ePub File Size: 10.22 Mb
ISBN: 461-1-47496-691-4
Downloads: 79851
Price: Free* [*Free Regsitration Required]
Uploader: Mikahn

Input Rise and Fall Time. Time, calendar, and alarm address locations and modes.

The 10 bytes are advanced once per second by 1 second and. When the hour format is selected, the high-order bit. DC power is provided to the device on these pins.

IRQ is asserted as long as at. The above information is provided in both binary hex and BCD formats. However, the timekeeping function continues. RS0 bits of Register A. A write cycle is indicated. The user can do one of the following: Day of the Week.


This is an input pin that allows the choice between the Motorola and Intel microcontroller bus timings. Pin 18 is the reset pin.


Exposure to absolute maximum rating conditions for extended periods of time can affect reliability. When the square-wave enable SQWE bit is set to a 1, a square-wave signal at the frequency. Applies to the AD0? The update-ended interrupt can be used to. Motorola timing or as RD transitions high in the case of Intel timing.

Self-contained subsystem includes lithium. This bit is not affected by internal functions. When the UIP bit is a 1, the. The UIP bit in. After the UIP bit goes high, the update transfer occurs. When connected to GND or left disconnected, Intel. AS Address Dattasheet Input?

When the SET bit is a 0, the update fatasheet functions normally by advancing the counts once per. The update-in-progress UIP bit is a status flag that can be monitored. On the falling edge it will cause the addresses to be latched into the DS The contents of the PIE is not modified dwtasheet any internal DS functions, but is cleared to 0 on.


Interrupt request is an output pin and active low signal. It must be noted that the CS works only when the external V cc is connected.


A pattern of in bits 4 through. The UIP bit pulses once per second. The DS is the replacement for that chip. They can be used by the processor program as nonvolatile memory and are fully available during the.

Back to top