INFORMATION FOR. INTERLINE Colour. Gloss Level. Volume Solids. Typical Thickness. Theoretical Coverage. Practical Coverage. Method of Application. PRODUCT DESCRIPTION. A two pack epoxy holding primer. Protection for freshly blasted steel in tank coating products involving Interline g/kg of liquid paint as supplied. EU Solvent Emissions Directive (Council. Directive /13/EC). Interline Epoxy Tank Holding Primer.
|Published (Last):||10 September 2015|
|PDF File Size:||4.97 Mb|
|ePub File Size:||4.70 Mb|
|Price:||Free* [*Free Regsitration Required]|
Consult your local International Paint representative for specific recommendations. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions.
Prior to use, obtain, consult and follow the Material Safety Data Sheet for this product concerning health and safety information. International Paint should be consulted to confirm that the tank coating is suitable for the range of cargoes to be carried.
Allows for more flexible working procedures whilst not detracting from the chemical resistance of the completed coating scheme. Actual safety measures are dependant on application methods and work environment.
Do not allow material to remain in hoses, gun or spray equipment.
The history and age of the steel and interlien method of working can have a significant effect on the paint consumption. Thoroughly flush all equipment with International GTA Clean all equipment immediately after use with International GTA Application by roller is recommended for small areas only.
The drying times and overcoating intervals may alter due to various on-site factors such as tank configuration and niterline rates. DO NOT thin more than allowed by local environmental legislation.
Take precautions to avoid skin and eye contact ie. Do not exceed pot life limitations. Use International GTA only in exceptional circumstances. Store in dry, shaded conditions away from sources of heat and ignition.
Consult your International Paint representative for details. If you do not fully understand these warnings and instructions or if you can not strictly comply with them, do not use this product. Marine Coatings Marine chemicals Marine lubricants.
Consult your International Paint representative for specific recommendations. Recommended Tip Range 0. Petersburg, Innterline, phone: Always mix a complete unit in the proportions supplied. Read and follow all precautionary notices on the Material Safety Data Sheet and container labels. Multiple coats may be required to achieve specified film thickness.
A two pack epoxy holding primer. As application, environmental and design factors can vary significantly, due care should be exercised in the interkine, verification of performance and use of the coating. Technical and application data herein is for the purpose of establishing a general guideline of the coating application procedures. Material is supplied in 2 containers as a unit. Based on this, products supplied in different territories may not be approved to all of the standards listed above.
All surfaces to be coated should be clean, dry and free from contamination.
Test performance results were obtained in a controlled laboratory environment and International Paint makes no claim that the exhibited published test results, or any other tests, accurately represent results found in all field environments.
Proper ventilation and protective measures must be provided during application and drying to keep solvent vapour concentrations within safe limits and to protect against toxic or oxygen deficient hazards. Products Marine Coatings Marine chemicals Marine lubricants. VOC values are typical and are provided for guidance purposes only. Use in accordance with the standard Worldwide Marine Specifications.
Interline | Litnobiles
Frequency of cleaning will depend upon amount sprayed, temperature, relative humidity and elapsed time, including any delays. High pressure fresh water wash or fresh water wash, as appropriate, and interlind all innterline or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning.
In the event welding or flame cutting is performed on metal coated with this product, dust and fumes will be emitted which will require the use of appropriate personal protective equipment and adequate local exhaust ventilation.