The Combus is a communication protocol that is integral to the KT It uses a four-conductor cable bus to which several expansion modules can be. Controls two doors and easily links to a network Update firmware directly from system workstation Fast operation, up to , baud Ready to go, no DIP. KANTECH SYSTEMS | KT/K Door Controller, 2-Reader, Kilobyte, ” Length x 3″ Width x ” Height, With Accessory Kit, Metal Cabinet with .

Author: Kazishicage Fauran
Country: Tanzania
Language: English (Spanish)
Genre: Photos
Published (Last): 1 September 2017
Pages: 295
PDF File Size: 20.7 Mb
ePub File Size: 7.90 Mb
ISBN: 146-3-42375-299-7
Downloads: 24127
Price: Free* [*Free Regsitration Required]
Uploader: Kagataxe

Before I begin, let me tell you I do not have a lot of experience setting them up. Enter text from picture: Flash memory allows for firmware updates from an EntraPass workstation in just a few minutes. It provides connections for all peripheral devices necessary for a complete kanteh control system and can be linked with other door controllers to provide control over millions of doors.

Does anyone have any ideas? The KT uses high performance communication, proper grounding must be provided to ensure proper operation. Kantech will not accept any shipment whatsoever for which prior authoriza- tion has not been obtained. This battery must be replaced by a Kantech technician to avoid any risk of explosion.


Kantech Kt-300 2 Door Controller 128kb Memory Metal Cabinet

Sign up for a new account in our community. Got it, continue to print. Kt Compliance Specifications Backup battery provides operation of up to 12 hours but has been tested only 4 hours per Section 33 of UL, fifth edition. The KT was communicating via the RS port and you installed a VC to communicate via the RS port; c You were using the KT at a local site and now want to configure it for remote operation.

I am having issues with it. Power outputs are supervised and individually protected against short-circuits and surges by self-resetting PTC.


It uses a four-conductor cable bus to which several expansion 300 can be connected. Posted May 29, I tried the above steps but got no joy. Comments to this Manuals Your Name.

You need to be a member in order to leave a comment. Visual Status Indicators leds 2. Kantech KT Installation Manual 14 pages. I have it set up to run through a usb Connect the battery leads to the battery. All circuits are power limited. How do I assign it? I am having a similar problem with a kanech being connected via USB. Locking kqntech are also supervised for short and open circuits.

After all wiring is completed, apply power to the KT By pressing ‘print’ button you will print only current page. Connect the battery leads to the battery, and connect the AC transformer.


Product offerings and specifications are subject to change without notice. I have set the baud rates to be the same on the port and in the software and I have the correct serial. Don’t show me this message again. Become a hattrix end user. Then, connect the AC transformer.

Table of Contents Pre-Installation Information The blue heart beat lights flashes 4 times. The status that is seen says controller or module not assigned. Not all products include all features. Alarm Panel Integration Kits. This module allows a maximum of 16 outputs and a maximum of up to 50 mA per output. By continue to navigate through this site or by clicking Approve, you consent to the use of cookies on your device as described in our Privacy Notice.

In the event of a power surge or transient, a module may lock up and cease to communicate with the controller.

Back to top